Agilent | MassHunter Acquisition for TOF and Q-TOF rev. B.02.01 SP2

Agilent Life Sciences and Chemical Analysis Software Patches Download Area

The following software patches are available for download. Click on the patch you wish to download. At this point your browser will probably ask you what it should do with the file. Select "Save File" or similar option and download the patch to an empty subdirectory on your hard disk. For ZIP archives you will need PKUNZIP or similar utility to expand the ZIP file. Once the archive is expanded, follow the directions in the readme file.

Note: Only apply a patch to the particular revision of the Agilent software product for which it was intended. Applying patches to the incorrect revision of Agilent software may result in corruption of your application software and your data.

The Service Pack SP2 fixes the following defects in the MassHunter Acquisition for TOF and Q-TOF rev. B.02.01 software:

13241 Cannot calibrate the VWD model G1314E
16426 Chip Cube Time Table Is Clearing Upon New Chip Being Loaded
16464 CTC Cycles Larger than 50 Steps Crash or Close MassHunter Acquisition
17414 CTC Configuration View gets corrupted
17666 Ejecting ChipCube and loading method later causes timetable resets on Operate
17797 Driver for 1290 LC does not work with 1200 LC
18082 1290 Pump B1 Always Shows in MassHunter B.02.01 SP1 Display
18319 1290 Injector Program Reverts Back to Default
18545 The ―position name‖ information does not getting saved into method file.
18043 1290 ALS Illumination Cannot Be Controlled By MassHunter Acq B.02.01 SP1
18044 1290 Pump B1 Always Shows in MassHunter B.02.01 SP1 Display
18062 1290 DAD does not allow UV lamp to be turned off during the run whereas 1200 DAD allows it
18169 1290 DAD Lamp Intensity Test is Different Between B.02.01 and Lab Advisor
18537 Unable to set LC1290 TCC (G1316C) temperature to 100 C from MassHunter UI
18646 Binary Pump went to error state when optimization stopped
18674 Valve method become dirty when no change is made
17661 Try to load a method while Chip in standby and get a "Type Mismatch" error
16291 Acquisition rate changes to 4.55 after initial autotune on AJS
16328 Customer Requires Time Segments Shorter Than 30 Seconds
16357 Setting detector gain while operating in short mass range
16418 QUAD AMU module at the end of the initial auto tune
17461 Slicer current measurement destroys AC board
17506 Lens2Rf value does not persist when switching from Tune to Acq
17617 Corona Needle Current Fault On 6220 With Instrument In Standby
17872 Targeted MSMS: Acquisition time override in the table does not work as expected
19015 Serial Link Timeout Errors
19016 Chip Cube Requires Lower Limit On The Drying Gas

Installation instructions are in the Service Note G3335AA MASSHUNTER SOFTWARE-37B.